What are the welding skills of Robotic Soldering Machine


Release time:

2021-12-01

Robotic Soldering Machine is already a common machine equipment, so what are the points of attention for Robotic Soldering Machine welding, and what are the methods of Robotic Soldering Machine welding?

Robotic Soldering Machine is already a common machine equipment, so what are the points of attention for Robotic Soldering Machine welding, and what are the methods of Robotic Soldering Machine welding? Now let the editor of Robotic Soldering Machine manufacturer introduce to you the soldering method of soldering machine:

Robotic Soldering Machine

1. The Robotic Soldering Machine should be placed on the soldering iron stand.
2. The soldering machine must be tinned before use. The specific method is: heat the electric soldering iron, and when the solder can just be melted, apply flux, and then evenly spread the soldering tin on the soldering iron tip to make the soldering iron tip evenly eaten One layer of tin. Automatic soldering machine
3. To choose suitable solder, low melting point solder wire for soldering electronic components should be used.
4. Flux, use 25% rosin dissolved in 75% alcohol as a flux.
5.Robotic Soldering Machine soldering method, polish the pads and component pins with fine sandpaper, and apply flux. Dip a proper amount of solder with the soldering iron tip of a soldering machine and touch the solder joints. After the solder on the solder joints are all melted and immersed in the component leads, the soldering iron tip is gently lifted up and away from the solder joints along the pins of the components.
6. The soldering time of the soldering machine should not be too long, otherwise it is easy to burn the components. If necessary, use tweezers to clamp the pins to help dissipate heat.
7. The solder joints of the soldering machine should be in the shape of sine wave peaks, and the surface should be bright and smooth, free of tin thorns, and moderate tin quantity.
8. The integrated circuit should be soldered afterwards, and the soldering iron tip should be grounded reliably, or the residual heat should be used for soldering after power failure. Or use dedicated sockets for integrated circuits, and then plug in the integrated circuits after soldering the sockets.
9. After the soldering machine is completed, the residual flux on the circuit board should be cleaned with alcohol to prevent the carbonized flux from affecting the normal operation of the circuit.

The above is about the welding method of Robotic Soldering Machine, I hope it will be helpful to you.