The SMT cooling conveyor includes a barrel, a rotating shaft with a spiral plate, a bearing, and a driving device. There is a cooling water jacket on the outside of the cylinder of the SMT cooling conveyor. The two ends of the rotating shaft are empty pipes. The cavity of the spiral plate is connected with the empty pipes at both ends of the rotating shaft. The empty pipe flows out to form an inner cooling water channel.

(1) Material cooling range of the SMT cooling conveyor. the temperature difference between the maximum temperature and the minimum temperature, so as to design the cooling series of the SMT cooling conveyor, and the length of the single-stage cooling generally does not exceed 7 meters.

The SMT cooling conveyor manufacturer tells you that the cooling screw conveyor includes a barrel, a rotating shaft with a screw plate, a bearing, and a driving device. There is an outer cooling water jacket outside the cylinder, and both ends of the rotating shaft are empty pipes. The SMT cooling conveyor manufacturer tells you that the cavity of the spiral plate is connected to the empty tubes at both ends of the rotating shaft, and the cooling water flows from the empty tube at the inlet end through the cavity of the spiral plate and then flows out from the empty tube at the outlet end to form an inner cooling water channel. The material is cooled evenly during the conveying process, and the cooling effect is good.

SMT cooling conveyor, also known as cooling screw conveyor, cooling screw conveyor, its main function is to cool the high temperature material during the conveying process to achieve the normal temperature required.

This article will share the cooling principle of the water-cooled screw conveyor: 1. The SMT cooling conveyor manufacturer tells you that the tubular screw conveyor: choose the tube shaft and shell of the large diameter tube, and the double-layer tube can be sleeved together, so that The amount of water inside can be increased, and the temperature of the material can be quickly lowered.

PCB transfer and carrier organization. The manufacturer of the Mirae pick and place machine tells you that the conveying mechanism is an ultra-thin belt conveying system placed on the guide rail. Usually, the belt is installed at the edge of the track. Its function is to send the PCB to the predetermined position, and then send it to the bottom after placement.