Mirae pick and place machine manufacturers take you to understand the daily maintenance of manual placement machines
Release time:
2022-07-25
1. Check weekly. The manufacturer of the Mirae pick and place machine tells you that inspect the nozzle clamp to check the buffer action, if the action is not smooth, apply a thin layer of lubricant, and if the clamp is loose, tighten it. Move the lens to clean dust and residue from the lens.
1. Check weekly. The manufacturer of the Mirae pick and place machine tells you that inspect the nozzle clamp to check the buffer action, if the action is not smooth, apply a thin layer of lubricant, and if the clamp is loose, tighten it. Move the lens to clean dust and residue from the lens.
2. The Mirae pick and place machine manufacturer tells you that use the X-axis lead screw to check the lead screw for debris or residue, and clean it if necessary. X-axis guides Check the grease for hardening and residue adhesion. Y-axis lead screw Inspect lead screw for debris or residue and clean if necessary. Y-axis guides Check the grease for hardening and residue adhesion. W-axis screw Check the screw for debris or residue, and clean it if necessary. Air port Check the Y-ring and O-ring for aging, and replace them if necessary.
3. Monthly inspection, this part should be carried out by nozzle type and nozzle changing station. To move the LED light of the lens, the Mirae pick and place machine manufacturer tells you that check whether each LED is bright enough, if it is not bright, the whole LED part should be replaced. Nozzle Shaft Check the O-rings used for each nozzle shaft and replace them in time if they are found to be worn out.
4. The Mirae pick and place machine manufacturer tells you that use the X-axis screw to remove dust and residues, apply a thin layer of grease to the X-axis guide rails to remove dust and residues, and apply a thin layer of grease to the Y-axis guide rails by hand. Wipe off dust and residues, apply a thin layer of grease to the Z-axis rack and pinion by hand to check their movement, and apply a thin layer of lubricant to the rack transmission parts by hand if necessary.
5. R-axis drive belt. The Mirae pick and place machine manufacturer tells you to check its wear and tightness, and replace the belt or adjust its tightness if necessary. Wipe off dust and residues on the W-axis screw, apply a thin layer of grease by hand, and check whether the solenoid valve works normally. The conveyor belt is checked for wear and tightness, and if necessary, the belt is replaced or its tightness at high speed.
The above information is Mirae pick and place machine manufacturer's introduction and analysis of the daily maintenance of manual placement machines, hope it helps you.
CONTACT US
SHENZHEN HANSOME TECHNOLOGY CO.,LTD.
3rd Floor,Building A,Sha Tang Bei Fang Yong Fa Industrial Area,Sha Jing, Bao an, Shenzhen, China
Quick Contact HSTECH
Our team will feedback you in 2 hours
SAF Coolest v1.3.1.1 设置面板 TTMSX-AHTB-NZAWE-ZFS
无数据提示
Sorry,There is currently no content in the current column!
You can view other columns or return to Home