The IR curing oven uses a finned radiator and a stainless steel heating tube as the heat source, and uses the fan to heat the air by convection ventilation of the heating assembly. Through the heat transfer between the hot air and the material, the air is continuously replenished through the air inlet, and the moist air is discharged from the box. In addition, the temperature in the furnace is continuously increased, and the mold is gradually preheated.
 
IR curing oven preparation before starting
1. The post operator must be familiar with the structure performance, working principle, adjustment method, operation method and maintenance knowledge of the IR curing oven before starting the machine.
2. Check the status signs and sanitation status of the equipment.
3. Check whether the electrical system is in good condition, and whether the motor is affected by moisture and leakage.
 
IR curing oven operation process
1. First clean the trolley and the inside of the furnace.
2. Turn on the power switch of the power supply equipment, and turn on the "power switch" button of the equipment (turn the key knob to the right)
3. Open the furnace door, put the mold and materials on the trolley and push them into the oven, and close the furnace door.
4. Set the oven temperature, and turn on the oven "fan" and "heat up" buttons.
5. When the curing time is reached, open the furnace door, push the trolley out of the furnace door, and take out the cured materials.
6. When the work is over, turn off the "heat up" and "fan" buttons respectively to stop the heating system and the blower system from working.
7. Finally, turn off the "power switch" knob, close the main gate, open the furnace door, take out the dried materials, and the working procedure is over.
 
IR curing oven operation precautions
1. The oven installation site should be flat and smooth.
2. The electrical control personnel have dedicated management and maintenance; when the furnace box is not in use, the power supply should be cut off to ensure safety.
3. Do not put flammable and explosive items into the oven to avoid safety accidents.