How to maintain SMT cooling conveyor
Release time:
2021-10-19
SMT cooling conveyor is an auxiliary machine for the preforming machine specially designed to solve the adhesion and deformation of the rubber blank.
SMT cooling conveyor is an auxiliary machine for the preforming machine specially designed to solve the adhesion and deformation of the rubber blank.
The rubber blank is cooled by cooling water or cooling solution, and then forced air cooling, so that the rubber blank is not deformed and more stable. The machine is characterized by adjusting the horizontal stainless steel mesh belt throughout the entire process to control the operating speed, which matches all the cutting speeds of the preforming machine.
For the SMT cooling conveyor, the conveyor is also composed of multiple components. Any configuration of the SMT cooling conveyor is very important. The price of the SMT cooling conveyor is generally much more expensive than the usual packaging equipment, so it is OK. It can be seen that the maintenance of the SMT cooling conveyor is particularly important. So the chain can basically be called the core point of the chain conveyor, so its overhaul and its daily maintenance are very important. In order to help everyone better use the chain conveyor, I will use this article to talk about the maintenance and maintenance methods of the SMT cooling conveyor.
When we inspected the SMT cooling conveyor, we didn't feel that we should inspect that component this time. In fact, in order to ensure safety and prevent malfunctions during work, we need to conduct a thorough inspection before operation. First of all, when we buy a new chain, we find that the chain is too long, or sometimes it is too long due to the use of time, and it is difficult to adjust. At this time, carefully observe how long it is, and then remove the chain link according to the situation, but it must be an even number. The chain link should pass through the back of the chain, the lock plate should be checked on the outside, and the opening of the lock plate needs to face the opposite direction of rotation. The tightness of the chain should be appropriate, otherwise, if it is too tight, the power consumption will increase, and the bearing will be easy to wear; on the contrary, if it is too loose and heat, it will be easy to jump and drag the chain. The moderate tightness of the chain is: lifting or pressing down from the middle of the chain, the center distance between the two sprockets is about 2% to 3%. If our chain conveyor has been used for a long time and there is no other problem, but it is found that the sprocket is severely worn, when the sprocket is severely worn, new sprocket and new chain should be replaced in time. To ensure good meshing. You can't just replace one individually, otherwise it will accelerate the wear of the new chain or new sprocket. If one side of the sprocket is worn to a certain degree, it can be turned over and used, as long as the use time can be extended. The chain on the chain conveyor should be lubricated in time during work. This lubricating oil must enter the matching gap between the roller and the inner sleeve to improve the working condition and reduce wear.