The reason why the PCB of the PCB reject conveyor can be more and more widely used is that it has many unique advantages, which are rough as follows: The PCB of the PCB reject conveyor can be high-density. Over the years, the high density of printed boards has been able to develop correspondingly with the improvement of integrated circuit integration and the advancement of mounting technology.

PCB reject conveyor manufacturers tell you that PCB (Printed Circuit Board) can replace complicated wiring and realize the electrical connection between components in the circuit. PCB reject conveyor manufacturers tell you that it not only simplifies the assembly and welding of electronic products, but also reduces the workload of wiring in the traditional way, and greatly reduces the labor intensity of workers.

PCB reject conveyor manufacturers tell you that PCB (Printed Circuit Board) is an important electronic component, a support body for electronic components, and a carrier for the electrical interconnection of electronic components. PCB reject conveyor manufacturers tell you that because it is made by electronic printing, it is called a "printed" circuit board.

The SMT cooling conveyor includes a barrel, a rotating shaft with a spiral plate, a bearing, and a driving device. There is a cooling water jacket on the outside of the cylinder of the SMT cooling conveyor. The two ends of the rotating shaft are empty pipes. The cavity of the spiral plate is connected with the empty pipes at both ends of the rotating shaft. The empty pipe flows out to form an inner cooling water channel.

(1) Material cooling range of the SMT cooling conveyor. the temperature difference between the maximum temperature and the minimum temperature, so as to design the cooling series of the SMT cooling conveyor, and the length of the single-stage cooling generally does not exceed 7 meters.

The SMT cooling conveyor manufacturer tells you that the cooling screw conveyor includes a barrel, a rotating shaft with a screw plate, a bearing, and a driving device. There is an outer cooling water jacket outside the cylinder, and both ends of the rotating shaft are empty pipes. The SMT cooling conveyor manufacturer tells you that the cavity of the spiral plate is connected to the empty tubes at both ends of the rotating shaft, and the cooling water flows from the empty tube at the inlet end through the cavity of the spiral plate and then flows out from the empty tube at the outlet end to form an inner cooling water channel. The material is cooled evenly during the conveying process, and the cooling effect is good.